Tokyo Tech News

Tokyo Tech’s Meister fourth at 2023 Japan International Birdman Rally

RSS

Published: October 12, 2023

Meister, an official Tokyo Tech student club, has finished fourth in the 2023 Japan International Birdman Rally, held at Lake Biwa in Hikone, Shiga Prefecture in late July. The annual contest — the 45th of its kind — was broadcast on Japanese television by Yomiuri Telecasting Corporation on August 30.

Meister’s aircraft and pilot just after take-off

Meister’s aircraft and pilot just after take-off

Tokyo Tech was one of thirteen teams participating in the Human-Powered Propeller Plane category, in which planes and pilots are pushed by teammates before launching off a platform above the surface of the lake. The aim is to fly as far as possible via two designated checkpoints, and ideally, return to the platform. Meister’s pilot and plane flew 3,851.83 m before touching down on the surface of the lake.

To mark their comeback from a series of recent struggles, which included a suspension of activities due to COVID-19, a shortage of club members, and a crash just after take-off during a test flight, Meister named their latest aircraft REVIVAL. For a year, the team worked together to design and fabricate their plane, dreaming of the moment when REVIVAL would take to the skies.

The summer heat and a tricky headwind made the competition tough for the pilots. Meister flew smoothly over Lake Biwa for some 17 minutes but fell short of a podium position. This was, however, Tokyo Tech's best result in the contest since 2015. The team also won the SUPPORTER Award for their efforts in supporting the pilot.

Comments from participating students

Comments from Meister representative Mayu Irie
3rd year, Electrical and Electronic Engineering

We have been working hard to revive Meister as a strong student club, and our team named our aircraft "REVIVAL" to reflect these efforts.

On the day of the contest, the wind gradually picked up as we approached noon, and at one point the competition had to be suspended. We are slightly disappointed because we were expecting a podium finish. Still, our pilot worked very hard and flew gracefully under difficult conditions. I can say honestly that I have never been this impressed in my life! We also won the SUPPORTER Award, and I am grateful to all the Meister members who worked hard as a united team.

I would also like to thank our supporters and all those involved in this project. We could not have come this far without you.

Comments from REVIVAL pilot Subaru Kawami
4th year, Life Science and Technology

I felt a great sense of responsibility to pilot REVIVAL, and carried with me the feelings of all the club members who had built our aircraft through relentless trial and error. That said, I was truly happy to be entrusted with the engine and the piloting of REVIVAL by friends who had gone through various struggles together with me.

I will treasure building and flying this human-powered aircraft, all of which was a sentimental experience. I would like to express my sincere gratitude to everyone who supported us. Thank you very much.

The junior students who have been working with us for a year have already begun to build a new aircraft. I ask for your continued support for Meister as we strive to achieve new heights.

Comments from REVIVAL designer Yuya Nishimori
3rd year, Mathematical and Computing Science

For the past year, I have been trying to utilize my strengths in mathematics and programming to design, optimize, and analyze the entire aircraft, and to build the electrical system and steering mechanism. I have given it my all and worked hard together with other Meister members despite the long hours of work.

REVIVAL was severely damaged during the test flight just before the actual contest, and we worked frantically to repair the aircraft. In the end, we achieved a clean flight, which was extremely moving. We all shared these hardships, and we supported pilot Kawami from the bottom of our hearts.

I would like to thank everyone who followed us to the contest and those who supported us in various ways before our flight.

Working on propeller with millimeter-level precision
Working on propeller with millimeter-level precision

Aircraft based on image of phoenix, which symbolizes revival
Aircraft based on image of phoenix, which symbolizes revival

MEISTER working to make wing lighter
MEISTER working to make wing lighter

Drive component being stripped to reduce weight
Drive component being stripped to reduce weight

MEISTER members and their roles during the contest

  • Mayu Irie, Meister representative and Fairing Group member
    3rd year, Electrical and Electronic Engineering
  • Subaru Kawami, pilot and Propeller Group member
    4th year, Life Science and Technology
  • Yuya Nishimori, designer and Electrical Equipment Group head
    3rd year, Mathematical and Computing Science
  • Mao Yamagishi, support team leader and Fairing Group member
    2nd year, Mechanical Engineering
  • Ichiru Ando, Wings Group head
    3rd year, Life Science and Technology
  • Wataru Arimoto, Wings Group
    4th year, Mechanical Engineering
  • Haruhito Takeuchi, Wings Group
    3rd year, Physics
  • Takashi Shinoda, Wings Group
    3rd year, Mechanical Engineering
  • Shuhei Ito, Wings Group
    2nd year, School of Engineering
  • Moeka Tsukamoto, Wings Group
    2nd year, Mechanical Engineering
  • Shota Yamasaki, Wings Group
    2nd year, Mechanical Engineering
  • Akito Saito, Wings Group
    2nd year, Physics
  • Masaharu Otomo, CFRP Frame Group head
    3rd year, Systems and Control Engineering
  • Kentaro Murata, CFRP Frame Group
    3rd year, Materials Science and Engineering
  • Yuka Shiomatsu, CFRP Frame Group
    3rd year, Faculty of Science, Ochanomizu University
  • Kenji Ueda, CFRP Frame Group
    2nd year, Materials Science and Engineering
  • Miki Ono, CFRP Frame Group
    2nd year, Mechanical Engineering
  • Kohei Masuno, CFRP Frame Group
    2nd year, Computer Science
  • Hiroo Yashiba, CFRP Frame Group
    2nd year, Systems and Control Engineering
  • Manato Ishida, Propeller Group head
    4th year, Life Science and Technology
  • Daichi Tanaka, Propeller Group
    3rd year, Mathematics
  • Shinji Motoyoshi, Propeller Group
    2nd year, Chemistry
  • Ryotaro Kato, Propeller Group
    2nd year, Physics
  • Takuma Komaba, Fairing Group head
    3rd year, Mechanical Engineering
  • Keita Kusunoki, Fairing Group
    2nd year, Mechanical Engineering
  • Ayoob Ilyas, Fairing Group
    2nd year, Transdisciplinary Science and Engineering
  • Kohei Hasegawa, Electrical Equipment Group
    3rd year, Physics
  • Yuta Suzuki, Electrical Equipment Group
    2nd year, Mechanical Engineering
  • Takumi Hasebe, Electrical Equipment Group
    2nd year, Mechanical Engineering
  • Yuki Futami, Drive Group head
    4th year, Mechanical Engineering
  • Yuna Kato, Drive Group
    3rd year, Materials Science and Engineering
  • Ryosuke Suzuki, Drive Group
    2nd year, Electrical and Electronic Engineering
  • Akihiro Kaneko, Drive Group
    2nd year, Chemical Science and Engineering

Tokyo Tech Fund

Meister is supported by Tokyo Tech Fund

Tokyo Institute of Technology Fund

Contact

Meister, Tokyo Institute of Technology

Email meister.tokyotech@gmail.com

RSS